strength characteristics of quarry dust concrete

A BRIEF STUDY ON THE STRENGTH CHARACTERISTICS

A BRIEF STUDY ON THE STRENGTH CHARACTERISTICS

Soman K, et al studied the strength properties of concrete with partial replacement of cement by granite quarry dust.1 The research work carried out included an experimental investigation on strength properties of concrete made with 2.5% to 20% replacement of cement by quarry dust of less than 75 micron. The tests were carried This is part of a research on the structural characteristics of concrete using lateritic sand and quarry dust as fine aggregate. This paper presents the results of an experimental study investigating the flexural and tensile characteristics of concrete using combinations of lateritic sand and quarry dust as complete replacement for conventional river sand fine aggregate. concrete mix and quarry dust will be used as a fine aggregate. The gravity quarry dust is replaced by sand varying different percentage (0%, 15%, 30%, 45%, 60% 75%). then test data of quarry dust concrete will be compared with test data from a standard concrete without quarry dust Keywords Quarry, water cement ratio, compressive

Get More

Analysis of Concrete Made from Quarry Dust

Analysis of Concrete Made from Quarry Dust

May 12, 2015 Bricks with mix ratio 1010 (B5) containing 100 % quarry dust in replacing the sand gave the highest strength and the lowest water absorption compared to other ratios. All the quarry dust-sand-cement bricks exhibited a compressive strength much higher than the minimum requirement for standard bricks (5 N/mm 2) according to British Standard (BS ... May 01, 2017 Date 5/1/2017. Abstract To address the environmental constraints due to cement production and sand scarcity, strength properties of high-calcium fly ash (CFA)-based geopolymer concrete with quarry dust as fine aggregate is explored in this paper. River sand was replaced with quarry dust from 0 to 100% by mass. replacement of sand with quarry dust) and natural sand were compared. The compressive strength of concrete cube containing 100% replacement of sand with quarry dust the value ranges between 21.3 to 33.63 MPa. For a binder content of 300 kg/m 3. The maximum compressive strength of concrete cube containing 100% replacement of sand with quarry dust was found to be 33.63 MPa at

Get More

Experimental Investigation on Quarry Dust as a Partial

Experimental Investigation on Quarry Dust as a Partial

Dec 20, 2019 A reduction of 39% was observed in the split tensile strength when 60% of the MSand in concrete was replaced with quarry dust powder. The split tensile strength of concrete is more dependent on the quality of the paste than compressive strength. Jun 01, 2018 The flexural strength of concrete made with quarry dust as fine aggregate is higher (about 4.3%) than conventional river sand concrete. 2. The 1015% rule of thumb was found to be applicable in the estimation of flexural strength of quarry-sand concrete based on its compressive strength this and also meet the necessity of concrete, the cement is replaced by Marble powder and Quarry dust. In my project the experimental investigation has been carried out in order to determine the strength characteristics of concrete with partial replacement of cement separately by two materials i.e.1) Marble powder 2) Quarry dust.

Get More

STRENGTH AND DURABILITY PROPERTIES OF CONCRETE

STRENGTH AND DURABILITY PROPERTIES OF CONCRETE

quarry dust is reduced by the addition fly ash. This paper investigates the workability and strength characteristics of Quarry Dust Concrete (QDC) containing 0% to 30% of fly ash. Based on the test results, it can be concluded that combined use of quarry dust and fly ash can be shown improved strength in concrete and also Experimental Study on Partial Replacement of Quarry Dust and ... strength characteristics such as water absorption super plasticizer used in high performance concrete a set of 4 different concrete mixture were cast and tested with different ... strength of the concrete From Compressive Strength, Split Tensile Strength, Flexural Strength and the Durability test results it was observed that Quarry dust concrete is better than the Nominal concrete and the replacement of 60% of Quarry dust and 40% of Natural sand with the replacement of 15% of silica fume with cement and 1.0% of steel fibres proves to be optimum level to produce High Performance Concrete.

Get More

Strength and durability properties of quarry dust powder

Strength and durability properties of quarry dust powder

replaced concrete. For % quarry dust concrete workability is . and for % replacement of quarry dust concrete . compacting factor was observed. (d) e compressive strength results of quarry dust concrete (cubes) were obtained in the fourth series, where M, M, and M grades of concrete with , , and Oct 30, 2016 The maximum reduction in strength of quarry dust aggregate concrete (QDAC) when exposed to 400 C was found to be 55%. Mechanical properties such as compressive and tensile strength and modulus of elasticity of concrete containing fly ash and quarry dust aggregate is influenced by temperature, water binder ratio and fine to total aggregate ratio. concrete compressive strength and split tensile strength values are determined. Attempts have been made to study the properties of such SCCs and to investigate the suitability of Quarry Dust to be used as partial replacement materials for sand in SCC. Index Terms SCC, Fly Ash, Silica Fume, Quarry Dust,

Get More

PDF Strength Durability Characteristics of Concrete

PDF Strength Durability Characteristics of Concrete

This paper presents the results of concrete mix with partial replacement of fine aggregate by quarry dust and simultaneous partial replacement of coarse aggregate by laterite stone aggregate respectively on compressive strength, split tensile strength, flexural strength and workability of concrete. Concrete mixes containing 0%, 10%, 20%, 25 % and 30%, replacement (by weight) of fine aggregate ... Keywords - High performance Concrete, Quarry dust, Strength, Workability, Mechanical properties. 1.0 INTRODUCTION Concrete is a widely used material in the world. Based on global usage, it is placed at second position after water. Fine aggregate is an essential component of concrete. The most The test result indicates that crushed stone dust waste can be used effectively used to replace natural sand in concrete. In the experimental study of strength characteristics of concrete using crushed stone dust as fine aggregate it is found that there is increase in compressive strength, flexural strength and tensile strength of concrete.

Get More

PDF FLEXURAL AND TENSILE STRENGTH PROPERTIES OF CONCRETE

PDF FLEXURAL AND TENSILE STRENGTH PROPERTIES OF CONCRETE

when the percentage of the quarry dust increase from 0% to 15% and slightly decreased with 20% replacement at 50 days. Keywords Compressive Strength, Flexure Strength, Quarry Dust, Split Tensile Strength, Workability. I. INTRODUCTION The main Ingredients of conventional concrete are cement, sand and aggregate. clear picture that quarry dust can be utilized in concrete mixtures as a good substitute for natural river sand giving higher strength at 50% replacement. Index Terms- Concrete, quarry dust, river sand, compressive strength. I. INTRODUCTION oncrete is the most widely used composite material today. The effect on these replacement materials on Compressive Strength, Split Tensile Strength, Flexural Strength, Modulus of Elasticity and Water Absorption were studied and the results obtained were compared with the Control Concrete. It is observed that the optimum replacement percentages of GGBS and Quarry Dust are 40 % and 50 % respectively.

Get More

PDF Use of Quarry Dust to Replace Sand in Concrete An

PDF Use of Quarry Dust to Replace Sand in Concrete An

percentage of quarry dust varying from 20%, 25% and 30% replacement. The compressive strength results are presented in Figure no. 5. 5. CONCLUSIONS It is observed that the strength characteristics of quarry dust is same as sand. The chemical composition of quarry dust and sand possess that the strength property remains constant for both the ... Mix design has been developed for three grades using design an approach IS, ACI, USBR, RN.No.4 and BRITISH for both conventional concrete and quarry dust concrete. Tests were conducted on cubes and beams to study the strength of concrete made of Quarry Rock Dust and the results were compared with the Natural Sand Concrete. Vinay, M., Ramesh, V. Dr., and Geena, G. (2015) Experimental study on strength characteristics of concrete using fly ash aggregate and quarry dust. International Journal of Civil and Structural ...

Get More
Recent Posts